Skillet Cheese Biscuits

There's something wonderfully rustic about baking in a cast-iron pan on the stove-top. I suppose you have to enjoy crust, and with these babies, the crust contains crunchy bits of toasted cheese. It's a finicky pastry, because the temperature has to be well matched to the amount of time it takes to bake, or the pastry over-browns or, at worst, burns. Since the timing is so short it depends on the individual stove being used, so err on the side of caution and for your first try, set your stove to a lower temperature than you normally would.

1⅔ cup flour
2 Tbsps baking powder
½ tsp salt
¼ cup (2oz/58gr) cold butter cut into cubes
1 egg
¾ cup milk or buttermilk or yogurt
1 cup (3oz) grated Parmesan

1. Mix together dry ingredients
2. Add the butter pieces and pinch with your fingers to create a crumb texture. The secret is to have small globules of butter throughout the dough; really cold butter helps with this.
3. Make a well in the middle and crack in the egg - lightly whisk the egg in the well, add the milk and finally mix everything with a wooden spoon just until combined; try not to overwork the dough. It will be quite sticky.
4. Liberally butter an 8 to 10" cast-iron pan. Spread the dough over the bottom. Make cuts in the raw dough to form 8 wedges (tricky 'cause the dough is sticky). Turn on the heat to medium (or lower) and cover. After 5 minutes shake the pan to check if the dough is cooked enough to be unstuck and shifts along the bottom. If it does, gently lift to see if it has browned enough underneath and, if not, leave until it turns nicely golden. Flip and cook another 5 minutes. This part can be tricky - to flip, if your pan has rounded sides, you might be able to slide the biscuits onto a plate to flip it over into the pan or; try using two broad spatulas to lift onto a plate and do the same as above.
5. Again, test the biscuits by shaking the pan to see if it moves, and then gently lift to check the browning. If it's to your liking, turn the biscuits out onto a wire rack and allow to cool, at least long enough to handle, then break apart along the cut lines.